How to Use
This type of warming apparatus is of the convection type
It could be used in large room, with good ventillation
Operation
Please make sure that the supplying voltage and frequency is consistent
with the requirements of the product. (220-240V ~ 50/60Hz AC mains
supply capable of delivering 2400 Watts minimum. Most standard
household mains sockets are more than adequate.
After inserting the plug, turn the control to the desired setting.
There are 4 settings:
OFF
FAN ONLY (COOL BLOW FUNCTION)
LOW SETTING 1: 1200 W
HIGH SETTING 2: 2400 W
This heater is equipped with a thermostat. Turning clockwise will increase
the desired temperature (the heater will switch on more frequently).
Turning anti-clockwise will cause the heater to switch on less frequently.
Tip
: when the thermostat is turned completely anti-clockwise, the heater
will only switch on when the ambient temperature in the room is about
5 degrees centigrade. This is sometimes handy as a frost prevention
measure in greehouses etc.
Cleaning and Maintainance
Before cleaning, please unplug the heater first, and wait for it cool down
completely.
The appliance needs only external regular cleaning.
Do not clean with abrasive cloths or cleaners. Do not use chemical
solvents.
A soft cloth moistened with a mild detergent solution is ideal.
On occasion, compressed air can be used to clear dust from the fan intake
or heater vents. THE HEATER MUST BE COLD AND DISCONNECTED
FROM THE MAINS SUPPLY BEFORE DOING THIS. ONLY PERFORM
THIS OPERATION IN A WELL VENTILLATED AREA
Helpline Number:
0871 221 3615
WWW.PIFCO-PRODUCTS.CO.UK
Helpline Number: 0871 221 3615
WWW.PIFCO-PRODUCTS.CO.UK
Trouble shooting
If the heater doesn’t work, please check whether the power cord is
properly connected
If the heater accidentally overheats eg from being covered, obstructed
or being too close to external surfaces, it will cut out. If this happens,
unplug the heater and allow to cool for 10 minutes. Re-connect the
heater and is should work again.
Also ensure that the product is on a flat, stable surface
.
Please do not attempt to disassemble the heater. There are no user
serviceable parts inside.
P44007.indd 6-7
10/05/2012 11:43
