piezosystem jena ENT, Инструкция по эксплуатации

Страница: 44 / 52

Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
44
7.2.3.7.
module ENV 40 C/CSG/CCP
You can read the common technical data in chapter ENV40. Additional technical
data’s you find in the following table.
width of the module itself 6TE = 30,5mm
connector for piezo element LEMO 0S.302
connector for measuring system LEMO 0S.304 (CSG)
LEMO 0S.650 (CCP)
display (LEDs) red LED for ON
red LED for UDL (Under Load)
red LED for OVL (Over Load)
DC OFFSET 3/4-turn potentiometer
switch “closed loop“
switch for switching closed loop on or off
type of feedback controller PID
measurement system none (ENV40C)
strain gauge (ENV40CSG)
capacitive (ENV40CCP)
modulation input (MOD) [V]
0...10, SMB (input resistance 10k

)
monitor output (MON) [V] ENV40C:
-1..15, SMB (output resistance 100k

)
ENV40CSG / ENV40CCP:
0..10, SMB (output resistance <1k

)
table 9: technical data voltage amplifier ENV40C / CSG / CCP
7.2.3.8. module ENV 40 nanoX **
These amplifiers were developed for use with nanoX-positioners only. They are
not suited to drive other piezo actuators.
The amplifiers of the series „nanoX“ differ from the standard ENV40 (or rather
SG/CAP) amplifiers in the following points.
power [W] max. 12
output voltage [V] -10 ... 150
output nanoX [V] 150 ... -10
output current [mA] 2 * 40
connector for piezo-element ODU series L (3pin)
table 10: technical data module ENV 40 nanoX **