- -
17
(9) ALARM SENSOR SETUP
?
Sensor Record Time
This function provides the setup of sensor recording time after a sensor device has
been triggered.
?
.Move the cursor to
SENSOR SETUP
and press
ENTER . S
elect the
SENSOR RECORD TIME
by pressing
ENTER
again.
?
The
Sensor Record Time
is configured at 5-second intervals from 5 Sec. to 30 Sec.
by using the front panel arrow buttons. Sensor recording is only active during the time
period when the function
S
has been set on the
Record Schedule
menu.
?
Alarm Out Time
Once a sensor / alarm trigger is received, the duration of the output relay can be
set to: 0, 5, 10, 15, 20, 25, 30 seconds, or continuous (CONT). The relay has a
normally open contact, and should be limited to circuit loads less than one amp.
NOTE: The alarm output will only function during hours that are set to “S” in
the RECORD SCHEDULE menu.
?
Channel 1-4 (Open or Not Installed)
Any channel sensor channel that you wish to be active must be set to “OPEN”.
A trigger to a particular channel will activate recording of that channel only.
?
Press
MENU
to exit
SENSOR SETUP
.
SENSOR SETUP
SENSOR RECORD TIME 30
ALARM OUT TIME 00
CHANNEL-1 NOT INSTAL LLED
CHANNEL-2 NOT INSTAL LLED
CHANNEL-3 NOT INSTAL LLED
CHANNEL-4 NOT INSTAL LLED
PRESS(
< >
), THEN (ENTER)
PRESS (MENU) TO EXI T
