•
Burst Mode State – The power up state of the burst mode is the first
option selected. The LCD display will show either
bUF
for burst off
or
bUo
for burst on. You can toggle between these 2 states by
pressing either the
UP
or
DOWN
buttons.
•
Scan Type – There are 3 scan types you can select. If the LCD display
shows
SCb
scanning will proceed until a busy (unsquelched)
frequency is reached.
SCC
will cause the radio to scan until a clear
channel (squelched) is reached.
SC-
is the manual scan mode and you
must stop the scanning by pressing the appropriate button the FT-726
transceiver. These 3 scan types are functionally the same as those
selected with the 3-position slide switch on the old Scan Switch board.
Pressing either the
UP
or
DOWN
buttons will toggle between these
3 modes.
•
Scan Stop – The 2 scan stop setting select what the transceiver does
when the appropriate scan activity has been reached. In the Scan Stop
mode,
StP
showing on the LCD display, the scanning will stop on the
interrupting event. If the scan is in the pause mode,
PAU
showing on
the LCD display, the scanning will pause on the interrupting event.
You can leave the Scan / Burst setup mode by either pressing and holding
the
BURST / SCAN
button, in which case your newly adjusted
parameters will be saved, or by waiting about 60 seconds until the Scan /
Burst setup mode times out. If the Scan / Burst setup mode times out, the
parameter you changed will not be saved.
http://www.piexx.com/
