Installation
1. Remove the top cover from your FT-726 transciever. There are
seven screw holding the top cover including one under the front
handle mounting plate on the front right of the transceiver. Be
careful when you lift the cover as there are wires attached to the
speaker and the Scan Switch board.
2. Unplug the two wires from the speaker and the 12 pin
connector from the Scan Switch board. The cover will now be
free.
3. Remove the 2 screws holding the Scan switch board and its
nameplate on the top cover of the transceiver.
4. Install the
FT-726T and its new nameplate in the spot
vacated by the old Scan Switch board.
5.
Install the 12 position cable onto the connector pin strip
on the FT-726T. Note that there is a missing pin on the
FT-726T that should align with the missing pin hole in
the connector.
6.
Reconnect the Speaker leads and replace the cover.
