Pier Deco AQUAMASSAGE PD-890, Руководство пользователя

Страница: 6 / 8

Vérifier si les boyaux d’alimentation sont coincés.
Vérifier les tamis des joints d’étanchéité à l’entrée d’eau et de la cartouche ther
Vérifier si les boyaux d’alimentation sont coincés ou tordus.
La température est difficile à ajuster en
tartre. Voir le vidéo identifié dans la section entretien à la page 5 de votre manuel du
Toute garantie sera nulle et sans ef fet en cas de modification du mécanisme interne ou de toutes
Page 6
TROUBLESHOOTING
PROBLEM DIAGNOSTIC
Water temperature is not hot
enough. 1. Press on the push buton on the top of the thermostatic handle and
turn counterlockwise.
2. The water heater temperature is set at 60°C (140°F).
3. Make sure that there is no air in the water pipes.
Noise is coming from the water
line when the shower column is
in function. 1. Look for air pockets in your plumbing .
2. Look for upside-down “U” in all the pipes going to the shower, make
sure that they are not kinked or twisted
Water temperature gets
increasingly colder. The problem is probably coming from your water heater, try this little test:
Turn on the hot water faucet of the sink and see if the water is hot, if the
water is cold the problem is coming from the water heater. the tank may
be empty, wait 30 min and try the test again.
Cold water comes out when the
faucet is set on hot water. Check the two stainless steel hoses at the back of the shower column, the
hot and cold are probably reversed.
The temperature is hard to
adjust when the thermostatic is
turned. The thermostatic cartridge probably needs to be soaked in a deliming
solution. Please refer to the maintenance section on Page 5 of your
owner’s manual.
The water pressure is going
down gradually. 1.
Verify the filtres in the gaskets at the water entry as well as on the
thermostatic cartridge.
2. Look for upside-down “U” in all the pipes going to the shower, make
sure that they are not kinked or twisted.
ATTENTION
Any warranty will be void and ineffective in the case of a modification of the internal
mechanism or any other component of the product. If this troubleshooting guide does not help
you to find or fix the problem. Please call : 450-417-3740.