SPI-14/18-2150
3
Rev. 06/03
Ph: 800-421-6511
www.picomacom.com
Safeguar
ds
11.
Power Sources:
This product should be oper
ated only from the
type of power source indicated on the marking label. If you are not
sure of the type of power supplied to your home, consult your appli-
ance dealer or local power company.
12.
Power-cord Protection:
P
ower-supply cords should be routed
so they are not likely to be walked on or pinched by items placed upon
or against them. Pay particular attention to cords and plugs, conven-
ience receptacles, and the point where they exit from the appliance.
13.
Lightning:
F
or added protection for this product during a lightning
storm, or when it is left unattended or unused for long periods of time,
the unit should be disconnected from power source.
14.
Power Lines:
An outside antenna system should not be located
in the vicinity of overhead power lines, other electric light or power cir-
cuits, where it can fall into such power lines or circuits. When installing
an outside antenna system, extreme care should be taken to keep
from touching such power lines or circuits as contact with them may
be fatal.
15.
Overloading:
Do not o
verload wall outlets and extension cords as
this can result in risk of fire or electric shock.
16.
Object and Liquid Entry:
Ne
ver push objects of any kind into this
product through openings as they may touch dangerous voltage
points or short-out parts that could result in a fire or electric shock.
Never spill liquid of any kind on the product.
17.
Servicing:
Do not attempt to ser
vice this product yourself as
opening or removing covers may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel.
18.
Damage Requiring Service:
Unplug this product from the w
all
outlet and refer servicing to qualified service personnel under the fol-
lowing conditions:
a.
When the po
wer-supply cord or plug is damaged.
b.
If liquid has been spilled, or objects ha
ve fallen into the product.
c.
If the product has been e
xposed to rain or water.
d.
If the product does not oper
ate normally by following the oper-
ating instruction. Adjust only those controls that are covered by
the operating instructions. An improper adjustment may result in
damage and will often require extensive work by a qualified tech-
nician to restore the product to its normal operation.
e.
If the product has been dropped or the cabinet has been
damaged.
f.
When the product e
xhibits a distinct change in performance—
this indicates a need for service.
19.
Replacement Parts:
When replacement par
ts are required, be
sure the service technician has used replacement parts specified by
the manufacturer or have the same characteristics as the original
parts. Unauthorized substitutes may result in fire, electric shock or
other hazards.
20.
Safety Check:
Upon completion of an
y service or repairs to this
product, ask the service technician to perform safety checks to deter-
mine that the product is in proper operating conditions.
21.
Outdoor Antenna Grounding:
Bef
ore attempting to install this
product, be sure the antenna or cable system is grounded so as to
provide some protection against voltage surges and built-up static
charges.
a.
Use No
.10 AWG (5.3mm) copper, No.8 AWG (8.4mm) alu-
minum, No.7 AWG (10mm) copper-clad steel or bronze wire or
larger, as ground wire.
b.
Secure antenna lead-in and g
round wires to house with stand-
off insulators spaced from 4 feet (1.22m) to 6 feet (1.83m) apart.
c.
Mount antenna discharge unit as close as possib
le to where
lead-in enters house.
d.
A dr
iven rod may be used as the grounding electrode where
other types of electrode systems do not exist. Refer to the
National Electrical Code, ANSI/NFPA 70-1984 for information.
e.
Use jumper wire not smaller than No
.6 AWG (13.3mm) copper
or equivalent, when a separate antenna grounding electrode is
used.
NOTE TO THE CA
TV SYSTEM INSTALLER
THIS REMINDER IS PR
OVIDED TO CALL THE CATV SYSTEM
INSTALLER’S ATTENTION TO ARTICLE 820-22 OF THE NEC
THAT PROVIDES GUIDELINES FOR PROPER GROUNDING
AND, IN PARTICULAR, SPECIFIES THAT THE CABLE
GROUND SHALL BE CONNECTED TO THE GROUNDING
SYSTEM OF THE BUILDING, AS CLOSE TO THE POINT OF
CABLE ENTRY AS PRACTICAL.
SPI-14/18-2150 Manual.qxd 10/20/03 9:33 AM Page 3
