DSP806
6
Rev. 01/03
Ph:800-421-6511
www.picomacom.com
Operation and Controls
®
1
1
2
4
600W MAX
RF IN
IF OUT
IF IN
RF OUT
13
14
15
16
17
12
CAUTION: FOR CONTINUED PROTECTION AGAINST FIRE
HAZARD, USE ONLY WITH SAME TYPE 0.5A 125V FUSE
POWER
AURAL CARRIER
ANALOG
DIGITAL
A/D
I
N/O
UT
STORE CH MODE
CH
RF OUT
LEVEL
OUTPUT
TEST
-30 dB
DSP806
806MHz Agile PLL SAW-Filtered Digital / Analog Processor
120 Vac
60 Hz 25 W
3
5
6
7
8
9
10
11
Front and Rear Panels
1. Power on LED:
Indicates power is on when lit.
2. Aural Carrier:
Adjust audio/video ratio, when in analog mode only,
with this control.
3. Channel display:
Displays input and output channels and channel
mode.
4. Analog /Digital LED’s:
Indicate that processor is operating in ana-
log or digital mode.
5. A/D:
Button toggles between analog and digital modes.
6. IN/OUT:
Use this button to select input and output channels.
7. Store:
Press this button to store current programming
information in the non-volatile memory.
8. Channel Mode:
Use to select CATV, HRC, IRC or off-air channels.
9. CH:
Use these buttons to select desired channel.
10. Output Adjust:
Use to set level of RF output.
11. -30 dB Test Point:
Used to monitor output level.
12. RF Out:
Connect this port to channel combiner system.
13. IF In:
Input from I.F. scrambler or I.F. output.
14. IF Out:
To I.F. input or scrambling device.
15.
RF In:
Connect RF source (antenna or cable) to this port.
16. Convenience outlet:
Provides 125Vac, 60Hz, 600W max. supply.
17. Power Connection:
Connect power cord to this input.
Channel Type Selection
Press the CH. TYPE button
to cycle through the selec-
tion. Upon selection press
STORE.
CHANNEL TYPE: CATV
CHANNEL TYPE: HRC
CHANNEL TYPE: IRC
CHANNEL TYPE: STD
CHANNEL TYPE INDICATOR
Input and Output Channel
Selection
INPUT CHANNEL (STD/UHF)
INPUT CHANNEL INDICATOR
INPUT CHANNEL
INPUT CHANNEL (CATV)
INPUT CHANNEL INDICATOR
INPUT CHANNEL
OUTPUT CHANNEL (CATV)
OUTPUT CHANNEL INDICATOR
OUTPUT CHANNEL
Press the IN/OUT button to
select either input or output
channel.
"I" = input channel,
"U" = output channel.
Then use
CH
buttons to select desired
channel number. Upon
selection press
STORE
button for a few seconds.
Note:
UHF is available only
as an input channel and
appears on front panel as
shown at right.
