PIAGGIO Vespa GTS 300 HPE 2019, Руководство пользователя

Страница: 30 / 104

The remote control is powered by internal batteries that get discharged after extended
used; If the LED turns on when the button is pressed, the remote control is working
properly.
You may need to replace the batteries if the remote control fails or if its range of
operation is reduced. To separate the two halves of the remote control, insert the blade
of a plain slot screwdriver at one point on the edge and slide it all around.
Once the remote control is open, remove the two batteries from the contact terminal.
Install the two new
CR2016 batteries with the positive pole facing the contact terminal.
Reassemble the remote control by pressing the two clip-on halves gently with your
fingers.
01_26
Remote control programming (01_26)
To program the new radio commands, do the following:
1. disconnect the battery of the vehicle;
2. reconnect the battery of the vehicle;
3. within 5 seconds of reconnecting the battery, simultaneously press buttons
"
1 " and " 3 " on the remote control twice. the «Bike Finder» device will confirm
the process with an optical signal by the quick flashing of the turn indicator;
4. the programming of the new radio command generates the end of the pro-
cedure and the system is ready for use.
If it is necessary to erase a radio command from the memory of the device, it will be
necessary to repeat the programming 4 times even with the same remote control, in
order to recover the 4 provided memories.
CAUTION
TO STORE THE OTHER REMOTE CONTROLS TO MEMORY (4 MAXIMUM) YOU
NEED TO REPEAT THE WHOLE PROCEDURE AGAIN. FAILURE TO CARRY OUT
THESE OPERATIONS WITHIN THE INDICATED TIMES WILL RESULT IN THE
REMOTE-CONTROL UNIT KEY PROGRAMMING PROCEDURE BEING ABAN-
30
1 Vehicle