PIAGGIO Beverly Tourer 125, Руководство по обслуживанию станции

Страница: 207 / 278

Check components
- Check that the rotor does not show abnormal wear or dents;
- Check that the rotor shaft is not rusty;
- Check that there is no rust on the bearing seats or the ceramic seal;
- Check that the drive does not show dents and that it is perfectly integral with the steel hub.
With a hot air gun heat the flywheel cover on the
inner side.
- Place the flywheel cover on the ring base follow-
ing the same procedure as for removal.
- Place the two bearings on the specific punch.
- Use grease to keep the bearings on the appro-
priate tool.
- Use a plastic mallet to insert the bearings on the
housing up to the stop.
- Assembly the ceramic ring and the correspond-
ing rubber gasket. The ceramic ring chamfering
should always face towards the gasket.
- Lubricate the rubber gasket and insert the unit on
the flywheel cover.
Use the punch of the appropriate tool manually if
necessary.
Insert the drive on the guide on the support base
facing part of the appropriate tool, being careful to
check that the convex part faces upwards.
Beverly 125
Cooling system
COOL SYS - 207