PIAGGIO Beverly 400 I.E, Руководство пользователя

Страница: 46 / 82

03_16
03_17
03_18
Checking the brake oil level (03_16, 03_17)
The brake fluid tanks are located on the pumps under the front handlebar cover(front
on the right-hand side, rear on the left-hand side).
The procedures to checking the brake fluid level for the front and rear brakes are
identical.
Proceed as follows:
1 . Place the scooter on its centre stand and make sure the handlebar is centred;
2 . Loosen screw « A » and remove cover « B »;
3 . Check the fluid level through the respective sight glass « C ». A certain lowering of
the level is caused by wear on the pads.
Should the level appear to be below the minimum mark, please contact an Authorised
Service Centre or Dealer in order to have a thorough inspection of the braking system
carried out.
Braking system fluid top up (03_18)
Proceed as follows:
Remove tank cover « D » and loosen the two screws « E » and top-up the brake fluid
level using only the prescribed brake fluid and without exceeding the maximum level.
Under standard climatic conditions, replace coolant as indicated in the scheduled
maintenance table.
This operation must be carried out by trained technicians; take your scooter to an
authorised Service Centre or Dealer.
WARNING
BRAKE CIRCUIT FLUID IS VERY CORROSIVE; MAKE SURE THAT IT DOES NOT
COME INTO CONTACT WITH THE PAINTWORK
CAUTION
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID.
46
3 Maintenance