PKI-0081
-2-
Please read the installation procedures thoroughly beforehand.
●
In order for the lamp to safely perform at it’s full potential, use the relay harnesses that comes with your PIAA light kit.
●
All work procedures should be carried out in a location with adequate space. Set the vehicle’s transmission to parking
position.
Turn
off the engine and apply the parking brake.
●
Make sure the engine compartment is adequately cool before starting work. Do not begin work if engine parts such as
radiator, oil-cooler or turbo parts are still hot.
●
Do not add additional holes to the main body of the lamp. Do not apply adhesives or stickers to the lamp parts.
●
Do not modify the lamp harness or the switch harness in any way. Such modifi cations may cause overheat or short circuit.
It may cause the vehicle to catch fi re. PIAA will not be liable for any damage caused by such modifi cations.
●
When removing the battery terminals, do not touch the (-) and (+) terminals simultaneously.
An electrical shock may occur. Wear rubber gloves when carrying out work procedures.
●
Make sure the (-) and (+) terminals do not make contact with metal. It can be extremely dangerous if a short circuit occurs.
●
Make sure all bolts are tightly secure. If there are any loose bolts, tighten them accordingly.
●
After installing the lamp, adjust the lamp so the beam illuminates at least 40m in front of the vehicle. Also, adjust the lamp
slightly aside so that it does not shine directly into the eyes of the opposing vehicle’s driver.
(as
traffi
c laws stipulate -refer to p.7 for adjustment procedures)
●
When the battery terminal is removed, memory related to the clock, radio, audio system etc, will be aff ected.
After all work procedures are completed, reset to the original settings.
(For adjustment procedures refer to your car's instruction manual)
●
When installing the wiring harness, strictly follow the cautionary points mentioned below. Incorrect or faulty wiring may
cause the lamp to operate incorrectly. In some cases, it may cause the vehicle to catch fi re.
●
Before starting installation, always remove the (-) and (+) terminals.
Always remove the (-) terminal fi rst and make sure a short circuit does not occur.
●
When removing the battery terminals, always turn the key to OFF and remove the key. Turn off all other electrical units off
such as the light switch.
●
When removing the battery terminals, if a cord (for an electrical unit) is connected, wind a length of vinyl tape around the
(-) and (+) terminals to clearly identify them.
●
Verify the (+) terminal (white) and earth (black) before connecting.
●
Do not obtain (+) voltage from the alternator.
●
Install the switch harness in a position where it will not make contact with any high temperature parts such as the engine,
radiator or engine compartment.
●
Arrange the switch harness so that it does not make contact with moving parts.
●
If the switch harness makes contact with a part of the engine, apply heat-resistant cushioned tape around the harness.
●
When connecting the connector, insert until you hear an audible “click”
●
When removing the connector, hold the main body of the connector, press the locking tab down and pull outwards.
If excess force is used to pull the cord, it may damage the connection, which could cause overheat.
●
Make sure the harness does not sag. Use a harness band of vinyl tape to secure the harness to the intended position.
Caution Regarding Wiring / Please read thoroughly
