-5-
PKI-0037-4
【2】Relay Harness Installation Sequence
The numbers shown in the fi gure below indicate the sequence the parts should be installed.
Remove the (-) terminal from the
battery.
Remove the (+) terminal from the
battery.
Bring the relay connector into the
interior of the vehicle and connect
to the switch
’
s connector.
Take the (+) cord (white) and using the
one-touch connector, tie it together to the
vehicle
’
s (+) cord.
If only 1 lamp will be installed, seal the unused connector
with the Rubber cap and Dummy connector included in kit.
Connect the lamp harness
to the connector.
First ground the terminal
then take the (-) cord
(black) and connect it to
the (-) terminal.
Take the (+) terminal
cord (white) and attach
it to the (+) terminal and
connect to the battery.
Attach the (-)
terminal to the
battery.
After lamp has been installed, verify the relay
harness does not make contact with the
engine
’
s moving parts or sections that emit
extreme heat. Use the wire tie included and
secure to harnesses inside engine compartment.
Harness
Wire tie
※ Use a pair of pliers to verify the one-touch
connector is secure.
Switch
Relay
Battery
Cord
One-touch
connector
(+) cord (white)
(-) cord (Black)
Make sure to properly
secure the relay unit
using bolts or a harness.
The harness must also
be facing downward.
Double-stick tape for switch.
Place in area that is easily
accessible from driver
’
s seat.
Facing down
(+)cord (white)
Rubber cap
Dummy
connector
