-6-
PKI-0031
Temporarily set the bracket with masking tape
and then mark the correct position.
Remove the lamp harness and take out the lamp.
◆ If using only the double-side tape.
Install the lamp according to the marking made prior to installation.
Peel the protective sheet from the double-sided tape (Item 3) and apply.
● When using the double-side adhesive tape, clean the surface where tape will be applied. Use a clean cloth or sponge
and make sure dirt, grease, wax etc., are completely removed. If substances cannot be removed, it may not adhere
properly. In particular, avoid using leather wax, tire wax and also any type of organic solvent.
● When used in low temperatures, the adhesive substance tends to lose its strength. Use a drier or simply warm up
the adhesive surface before applying. When using a drier, avoid moving it too close to the bumper as it may cause
it to deform.
● After installation, avoid excess speeds and do not wash for 1 to 2 days.
● If applied incorrectly, a special double-sided adhesive tape is available at your local PIAA dealer.
◆ If screws are used.
(1) Loosen the hexagon bolt with the wrench
provided and remove the bracket from the
lamp.
(2) Peel off the protective sheet from the
double-sided tape and apply it to the
bracket.
(3) Fix the bracket in place with the screws.
(4) Install the lamp onto the bracket.
【3】Lamp Installation Procedures
● Make sure to set position properly before
permanently setting the lamp. Also,
thoroughly clean the surface of the
installation position beforehand.
1
2
3
Connector
Lamp Harness
Bracket
Masking Tape
Bracket
Screw
Hexagon bolt
Hexagon wrench
(Item 7)
Double-sided tape (Item 3)
