-6-
PKI-0041
Hexagon head bolt
(Item ③ )
Installation bracket
(Item ② )
（2）Combine the Installation bracket (Item ② ) and the
Hexagon head bolt (Item ③ ) as shown in the figure
below.
（3）Take 2 sets made up of the Hex nut and Slider
assembly that was combined in (1) put them into
the lamp main unit positions as indicated in the
figure. Be careful not to drop the Hex bolt out of
the Slider.
（4）Take 2 sets made up of the Hex nut and bracket
assembly that was combined in (2) and using the
Hexagon socket head bolt (M10/Item ⑥ ), screw it
firmly in place.
● If installing the lamp main units “RF10 and
“RF18” to the vehicles without combining them,
make sure to install 2 Installation brackets on 2
positions on the lamp main unit. With unit “RF6”,
one Installation bracket can be used in the center
but we recommend installing them on 2 positions.
● After the lamps are installed on the
vehicle, the Hexagon socket head
bolts (M10/Item ⑥ ) can be loosed
and the angle of the lamp can be
adjusted.
Advice
Hexagon socket head bolt
(M10) (Item ⑥ )
Hexagonal wrench
(M10) (Item ⑮ )
10°
10°
Slider ass
'
y
Hexagon socket
head bolt
(M10) (Item ⑥ )
Installation bracket
(Item ② )
Tightening torque：18ft/Ibs (24N-m)
