5 Installation
Q-521 Miniature Linear Stage
MP145E
Version: 1.0.1
23
Only install and operate the multi-axis system after you have read and understood the
user manuals of all components of the multi-axis system.
If you require special mounting adapters, contact our customer service department
(p. 47).
5.3.2
Setting Up an XY System
NOTICE
Screws and locating pins that are too long!
Screws and locating pins that are inserted too deeply damage the Q-521.
Pay attention to the depth of the mounting holes (p. 54) in the motion platform.
Pay attention to the maximum depth for the insertion of locating pins (p. 54) into the
motion platform.
Only use screws and locating pins of the correct length for the respective holes.
INFORMATION
Any model of the Q-521 can be used as lower or upper linear stage.
Designations in these instructions:
Lower linear stage: Forms the basis of the multi-axis system (X axis); is mounted on a
surface
Upper linear stage: Forms the Y axis of the multi-axis system; is mounted on the lower
stage rotated by 90°
Requirements
You have read and understood the general notes on installation (p. 17).
You have read and understood the general notes on setting up a multi-axis system
(p. 22).
The linear stages are disconnected from the electronics.
You have properly mounted the lower linear stage on a surface and connected it to a
protective earth conductor (p. 19).
You have accounted for the space required to route cables without bending and
according to regulations.
Tools and accessories
Mounting accessories from the scope of delivery of the upper linear stage (p. 12):
−
2 locating pins, 1.5 m6 x 4
−
2 socket head cap screws, M2x6
