PI M-403 2S Series, Руководство пользователя

Страница: 20 / 40

Troubleshooting
Incorrect configuration:
■
Check for anomalous parameter settings on the controller.
Positioner starts to move but stops after a short time.
Unusually high friction in the spindle-nut-system:
■
Clean the spindle and add new lubricant.
Positioner does not reach position with expected accuracy.
Motion parameters are not optimized:
■
Adjust the motion parameters according to the values given in this
document.
Positioner runs jerkily and not smooth enough.
Motion parameters are not optimized:
■
Adjust the motion parameters according to the values listed in this
document.
Positioner did not stop in time and ran into a hard stop.
The controller has not stopped the positioner in time:
■
Too high velocity. See chapter "Limit Switches".
■
Turn off the motor. If possible, you may push the positioner out of the
end zone manually.
■
The end of the leadscrew has an Allan wrench socket so it can be
cranked manually.
www.pi.ws M-403 MP 73E Release 2.0.1 Page 17