PI M-232.17, Руководство пользователя, Страница: 32 / 51

6 Start-Up
28 Version: 1.2 MP105E M-232 Linear Actuator
NOTICE
Damage or major wear to the mechanical system as a result of high
acceleration!

In the event of a malfunction of the motor controller, stop the motion
immediately.

Ensure that the end of the travel range is approached at low velocity.

Set your control signal so that the moving part does not stop abruptly or try to
continue moving at the end of the travel range.

Determine the maximum velocity for your application.
NOTICE
Damage from unsuitable controllers and PC software!
Unsuitable controllers and PC software can cause damage to the actuator.

If you use controllers and software from other manufacturers, before starting up
the actuator, check the technical data to make sure that they are suitable!
INFORMATION
The maximum velocity for a linear actuator with a stepper motor should be
determined in the application. If the commanded velocity is too high, the stepper
motor might stop without the controller detecting this condition.
INFORMATION
The handwheel of a linear actuator with stepper motor can be used to manually
retract and extend the pusher. Manually triggered changes in the position of the
pusher are
not recognized by the connected controller.
INFORMATION
The repeatability of the positioning is only ensured when the same limit switch is
always used for the reference move.

Always start reference moves to the same limit switch.