phytron
17
MA 1296-A010 EN
WARNING
– Serious injury from electric shock!
During electrical installation cables, connectors, etc. can be live.
- Before starting wiring, make sure that none of the power supplies are
connected to the primary side of the mains supply. Isolate the power
supplies from the mains or remove the appropriate fuses.
- All modules must be inserted and screwed into the
phyMOTION
TM
housing before powering up. If necessary, unoccupied module slots
must be covered with the supplied blank front plates.
Never operate the equipment when open.
- Do not plug or unplug the modules while powered.
- Do not plug or unplug the connectors while powered.
- If the equipment was energised, wait 3 minutes after power off to
allow the capacitors to discharge and ensure that there are no
residual charges on cables, connectors and boards.
Make sure not to leave free slots in between modules so the module addressing sequence
can work correctly.
Identify the correct slot position for your I1AM02 referring to your order and
documentation. The I1AM02 needs at least a preceding power module (POWM01,
POWM02) and the main controller module (MCM01).
Push the module carefully into the guide rail until the rear contacts the housing frame of
the
phyMOTION
TM
.
In the last few millimetres the module’s plug has to match with the backplane’s socket. You
should be able to push in the module with light pressure. In case you experience problems
move the module’s front plate slightly to the left and to the right while pushing in the
module, so that the plug’s pins can slide into the backplane’s socket.
As soon as the module’s front plate contacts the housing’s frame the module is integrated
properly and can be fixed with two electro-conductive bolts.
Now you can start with the electrical installation.
Содержание phyMOTIONT I1AM02.1
Страница 9: ...phytron 9 MA 1296 A010 EN 4 Technical Data 4 1 Declaration of Incorporation...
Страница 10: ...Manual I1AM02 MA 1296 A010 EN 10...
Страница 30: ...Manual I1AM02 MA 1296 A010 EN 30 Fig 6 6 wire LVDT RVDT wiring...
Страница 31: ...phytron 31 MA 1296 A010 EN Synchronisation Fig 7 Synchronisation wiring...