phytron
5
MA 1261-A006 EN
Safety Instructions
Further Manual
This manual is in addition to the following main manual:
“phy
MOTION
TM
Modular Multi-axis Controller for Stepper Motors”
- First, read the main manual and then continue with this manual.
i
Intended use:
The phy
MOTION
TM
is designed for operating in a drive system.
- An installation is allowed only if the requirements of the EC
Machinery and EMC Directives are conformed with.
i
Part of a machine:
This product is used as a part of a complete system, therefore risk
evaluations concerning the specific application must be made before using
the product.
- Safety measures have to be taken according to the results and be
verified.
- Personnel safety must be ensured by the concept of this overall
system (e.g. machine concept).
WARNING – Serious injury from electric shock!
If the phy
MOTION
TM
is not operated with SELV/PELV voltages, the risk of
dangerous voltages may be on the device. Touching these components
carrying high voltages can cause serious injury or death from electric shock:
- Always observe the safety concept SELV / PELV to ensure safe
isolation and separation of low voltage supplies from the mains.
WARNING – Serious injury from electric shock!
During electrical installation cables, connectors, etc. can be live.
- Before starting wiring, make sure that none of the power supplies
are connected to the primary side of the mains supply. Isolate the
power supplies from the mains or remove the appropriate fuses.
- All modules must be inserted and screwed into the
phy
MOTION
TM
housing before powering up. If necessary, unoccupied module
slots must be covered with the supplied blank front plates.
Never operate the equipment when open.
- Do not plug or unplug the modules while powered.
- Do not plug or unplug the connectors while powered.
- If the equipment was energised, wait 3 minutes after power off to
allow the capacitors to discharge and ensure that there are no
residual charges on cables, connectors and boards.
