phytron
13
MA 1261-A006 EN
5 Installation
5.1 Mechanical Installation of the MCM01 Module
Phytron always delivers the
phy
MOTION
™ completely assembled in order to make sure
you can start with the installation and the wiring right away.
Further manual
Detailed information on this subject is in a supporting manual:
“
phy
MOTION
TM
Modular Multi-axis Controller for Stepper Motors”
In case you receive an individually packed MCM01 as an expansion module or after repair
or service unpack the module in ESD protected area only.
CAUTION – Possible damage by ESD!
The modules of the
phy
MOTION
TM
consist of sensitive electronic
components that can be destroyed by electrostatic discharge voltages.
- Always store and transport single modules in ESD protective
packaging.
- Always handle the components in compliance with the ESD
protection measures.
- No liability is accepted for any consequences resulting from
improper handling or non-ESD-friendly packaging.
Before integrating or switching modules always make sure that the
phy
MOTION
™ is shut
down and the power supply is disconnected.
Identify the correct slot position for your MCM01 referring to your order and
documentation. The MCM01 is always installed directly on the right of a POWM01 module.
