First
Steps
© PHYTEC Messtechnik GmbH 2006 L-680e_1
21
Figure 14: Power Connection: PC-110 Card
•
You can now establish the FireWire connection. Insert one end of
the FireWire cable in the socket „In“ on the back of the camera and
the other side in the 6-pin FireWire socket on the interface card.
Caution!
Upon initial start up you have to install the corresponding driver
software on the PC. Without installing the driver, the camera will
function in a limited capacity or not at all.
Refer
for
driver installation.
2.3
Installation of the Driver Software
The appropriate software device driver has to be installed so that the
camera can be addressed by the application software.
This device can be found on the CD that is included with the camera.
You can also download driver software updates from the PHYTEC
website.
Caution!
Check first to see if your computer meets the following system
requirements for operating the camera:
•
Pentium II, 300 MHz or higher and 1394-interface
•
Graphic card with 24 or 32-bit color depth
•
Windows 2000/SP2 or Windows XP
•
DirectX 8.1 or higher
Make sure that your computer is equipped with this software.
Содержание FireWire-CAM-011H
