4
Two-
P
oint Padded
Positioning
B
elt
WARNINGS
•
Physipro Inc. positioning belts are reserved exclusively for use on mobility
aids (manual or power wheelchairs).
•
Always use the provided mounting hardware to install your positioning belt.
•
Never push or lift wheelchair with the positioning belt, doing so may cause
the belt to detach from the wheelchair which may result in damage or injury.
Always lift wheelchair with the rigid parts of the frame.
•
Before use, let the positioning belt get to room temperature to limit
discomfort caused by excessively hot or cold surfaces.
•
Avoid exposing your positioning belt to extreme cold or heat and avoid
prolonged contact to fluids or moisture. Never place near open flame.
•
Crash tests have not been conducted on this product and even if the mobility
aid in which it is installed has obtained the ISO-717619, it will not be
maintained.
INSTALLATION
Follow the installation procedure that applies to the type of seat rail installed on
your wheelchair (round or square tubing).
Belt
attachment
block
B
C
Round seat rails
(with belt attachment block)
Required tools
: 4mm and 5 mm Allen keys
Note –
Make sure anchor plates are placed in the corresponding adjustment
holes of the opposite seat rail and backpost.
Square seat rails
Required tool:
4mm Allen key
1.
Determine the correct location of the
anchor plates on the seat rails.
2.
Tighten screw
A
with a 4
mm Allen
key.
3.
Repeat these steps for the other side.
1.
2.
Determine the correct location of the anchor
plates on the seat rails.
Position both parts of the belt attachment
block to the seat rail.
3.
With a 5mm Allen key, tighten screw
B
firmly.
4.
With a 4mm Allen key, secure the anchor
plate to the attachment block by fastening
screw
C
.
5.
Repeat these steps for the other side.
A
