Photron Fastcam SA3, Руководство по оборудованию

Страница: 31 / 101

19 FASTCAM SA3 Hardware Manual
2.3.4. Connecting a PC
The system can have the operation of its functions performed from a PC using the Gigabit Ethernet
interface.
This section explains the required setup when connecting the system to a PC.
To connect a PC to the system, connect the system to a commercially available
1000BASE-T-compatible interface board with a LAN cable. For the LAN cable, prepare a UTP or
STP CAT5E (enhanced category 5) or higher LAN cable. (UTP: unshielded, STP: shielded)
The maximum cable length between the PC and the system is, compliant to the 1000BASE-T
specification, up to 100 m. One PC can connect to a maximum of 64 Photron Gigabit Ethernet
interface equipped cameras using a hub. When connecting multiple devices, connect through a
switching hub that can connect at 1000BASE-T. The maximum length of the cable that connects the
system (or PC) to the switching hub is also 100 m.

For operating instructions of Photron FASTCAM Viewer software, refer to "Photron FASTCAM
Viewer User's Manual".
2.3.5. Factory Default Setting
This system can be restored to the factory settings state.

For operating instructions of Photron FASTCAM Viewer software, refer to "Photron FASTCAM
Viewer User's Manual".
2.3.6. Memory Backup Battery (Option)
As an optional accessory, a battery set for conserving video information in the camera memorys is
avalible. In case of an outer power-fail, it can maintain the content of the memory for about 60
minutes in maximum. While powering the system using an outer power supply, the battery set will be
charged automatically.
Moreover, by pressing the “BATTERY CHECK” botton, LEDs can illumine and the charging status of
the battery can be confirmed even when the outer power supply is cut.

The longevity of battery is about 1 year. However, acknowledge that it could change according the
working circumstance.
For exchange of battery, refer to “7.1. Contant Information”, Page 80.