Main Ultrasonic
Features
• Main Ultrasonic Features:
• Ultrasonic generator – with an output frequency
of 40khz
• Timer – Can be turned on or off and set
anywhere from 1-30 minutes. To increase the
process timer by 1 minute press the up arrow
button. Hold the up arrow button to increase
in 10 minute steps. To decrease by 1 minute
press the down arrow button. Hold the down
arrow button to decrease in 10 minute steps.
• Temperature setting – To increase/decrease the
target temperature, press the up or down arrow
below the temperature display - temperature
is adjusted by 1 °C with each press between
0 and 80 °C. Holding the up or down button
will change the target temperature by 10°C.
The heater is used to keep fluid at temperature
between cleaning cycles; the ultrasonic
process also acts to heat the fluid.
Maintenance
• Empty the liquid out of your Photocentric wash
unit after either a month of usage, or when it
is no longer cleaning your parts properly, the
specific option will depend on how frequently
the machine is in use. To empty the liquid,
disconnect all power supplies and carefully
place the out valve (as seen in the below
diagram) over a bottle or container. Once
positioned turn the valve to release all of the
Photocentric cleaner from inside your wash
unit. This bottle or container needs to then be
sealed and disposed of following your countries
regulations and guidelines.
• Use a low power air compressor to clean dust
from the control system regularly
• Once a month on emptying the cleaner out
of your wash unit we also advise cleaning the
inside of the ultrasonic, please do this whilst
the machine is turned off, empty and not
connected to the power.
6
