Product Operation
Usage
The following instructions will ensure safe and
correct use of your Photocentric Wash unit:
• Step 1:
Place ultrasonic cleaner on a flat,
stable surface.
•
Step 2
:
Add Photocentric Cleaner to a level
where it will not overflow – approximately
2/3 full.
• Step 3:
Plug in the cleaner and switch
on via the switch at the rear of the unit if
present, otherwise at the wall socket. (If no
buttons are pressed, after eight hours your
ultrasonic cleaner will go into power save
mode. To restore power, press any button.
• Step 4:
Place your printed part, platform or
flexplate into the ultrasonic cleaner. If your
Photocentric Cleaner is completely full
of liquid with the printed parts immersed
then place the lid back in your cleaner to
prevent spillage.
• Step 5:
Set the timer to the relevant
settings; we advise a maximum of 5
minutes for most printed parts. Once set,
press the on button and this will enable the
ultrasonic function.
• Step 6:
To end the cleaning process, press
the corresponding key again; if nothing is
pressed the ultrasonic will stop when the
timer reaches 00:00 - if in use the heater
will switch on and off to maintain the fluid
at the target temperature.
PHOTOCENTRIC RESIN CLEANER
SKU. RESIN-CLEANER 5LTR
CLEANER
Resins
5
L
e
5060151503022
PHOTOCENTRIC RESIN CLEANER
SKU. RESIN-CLEANER 5LTR
CLEANER
Resins
5
L
e
5060151503022
WASH 15
Set ¼C
TEMP+
TEMP-
ON/OFF
ON
TIME+
TIME-
ON/OFF
Actual ¼
C
Minute
Second
Do not use w
hen empty
Minimum fill
level 2/3
Caution hot
liquid
Earth must b
e connected
ON
NO
05:00
05:00
5
4
