6. Product Operation
Instructions
The following instructions will ensure safe and
correct use of your Photocentric Wash unit:
• Step 1:
Place ultrasonic cleaner on a flat, stable
surface.
• Step 2
:
Add Photocentric Cleaner to a level
where it will not overflow – approximately
2/3 full. If using the bracket provided,
remove the basket from the wash tank.
• Step 3:
Plug in the cleaner and switch
on via the switch at the rear of the unit if
present, otherwise at the wall socket. (If no
buttons are pressed, after eight hours your
ultrasonic cleaner will go into power save
mode. To restore power, press any buttor.
• Step 4: Place your printed part or platform
fitted to the bracket into the ultrasonic
cleaner. If your Photocentric Wash 15 is
completely full of liquid with the printed
parts immersed, then place the lid back in
your cleaner to prevent spillage.
• Step 5: Set the timer to the relevant
settings. If you are using Photocentric
Cleaner check TDS for recommended
wash time. Once set, press the on button
and this will enable the ultrasonic function.
• Step 6: To end the cleaning process, press
the corresponding key again; if nothing
is pressed the ultrasonic will stop when
the timer reaches 00:00 - if the heating
function is in use the heater will switch on
and off to maintain the fluid at the target
temperature.
PHOTOCENTRIC RESIN CLEANER
SKU. RESIN-CLEANER 5LTR
CLEANER
Resins
5
L
e
5060151503022
PHOTOCENTRIC RESIN CLEANER
SKU. RESIN-CLEANER 5LTR
CLEANER
Resins
5
L
e
5060151503022
WASH 15
Set ¼C
TEMP+
TEMP-
ON/OFF
ON
TIME+
TIME-
ON/OFF
Actual ¼
C
Minute
Second
Do not use w
hen empty
Minimum fill
level 2/3
Caution hot
liquid
Earth must b
e connected
ON
NO
05:00
05:00
