Phonic Road Gear 160, Руководство пользователя

Страница: 8 / 16

page 8
RoadGear User's Manual PHONIC CORPORATION
page 9
PHONIC CORPORATION RoadGear User's Manual
9. Speaker Outputs
These jacks are used to connect to speakers, fed from the internal power amplifier. Both sets of outputs are
1/4” TS jacks, which boast an amazing 130 Watts of output (80 Watts for the RoadGear 160) per channel.
To use these, simply insert the RoadGear speaker cable’s 1/4” TS plug into them.
NB . Due to the fact that the signal has been processed by the power amp, these ports should be used in conjunction with speakers only
to avoid damaging any other equipment.
Controls and Settings
10. Peak Indicator
This indicator illuminates during high peaks of audio. If this LED illuminates
too often the input level of the corresponding channel should be reduced
to ensure the audio is not clipped when the level gets too high, which
would cause problems in the quality of audio.
11. High Frequency Control
This control alters the degree of high frequencies – or treble – in the audio
of the corresponding channel. Turn clockwise to increase the amount
of treble in the sound, and counterclockwise to decrease the amount.
Position the knob for a flat response when not in use.
12. Low Frequency Control
This control alters the degree of low frequencies – or bass – in the audio of
the corresponding channel. Turn clockwise to increase the amount of bass
in the sound, and turn counterclockwise to decrease the amount. Position
the knob at “0” if not in use.
13. EFX Control
This control adjusts the signal level of the corresponding channel to
be sent to the EFX (or monitor) mixing bus, for internal digital effect
processing (as well as the monitor outputs).
14. PAN/BAL Control
This alternates the degree or level of audio that the left and right side of
the main mix should receive. On mono channels, this control will adjust
the level of the monaural signal that the left and right should receive,
where as on a stereo channel, adjusting the BAL control will increase and
attenuate the left or right audio signals accordingly.
15. Level Control
This control alters the audio level of the audio feed to the main mix. This
control should be set to the extreme left when the channel is not in use.