Phonic Road Gear 160, Руководство пользователя

Страница: 6 / 16

page 6
RoadGear User's Manual PHONIC CORPORATION
page 7
PHONIC CORPORATION RoadGear User's Manual
Disassembling The RoadGear
To follow is the most convenient way to open
and close the RoadGear kits. Following these
instructions will ensure trouble-free setup of the
RoadGear.
1. You should fi rst unclip docking locks 1 and
2 (indicated below) on either side of the
RoadGear.
2. After unhooking these docking locks you can
then open the top lock
3 . This ensures the RoadGear pieces come apart
smoothly.3. Stand the powered mixer upright.
4. To re-assemble the RoadGear pieces, the same
order should be taken (side locks fi rst, followed
by the the top). This way the pieces will be held
securely and fi rmly together.
5. When using the RoadGear speakers, ensure
that the docking locks on the rear are locked
back into place, to ensure they don’t scratch the
surface on which they sit.
Initial Setup
Please ensure you take note of all setup
instructions listed in this manual. The RoadGear
160 and 260 are both used as normal PA
systems and therefore all care should be taken
in ensuring the correct setting up of equipment.
1. Disassemble the mobile RoadGear set and remove
the speakers from the top of the kit. Remove all
items you wish to use in your PA system from the
RoadGear’s storage area. Also, place the mixer
and speakers in a suitable place.
2. Connect the two speakers to the Powered Mixer,
via the supplied speaker cable. An optional
speaker stand may be used to increase the
height of the speakers. NB. No devices other
than speakers should be connected to the
speaker outputs. Doing so will likely cause
damage to the device. Also, guitar cables should
not be used to connect amplifi ers to speakers.
3. Plug all necessary instruments and equipment
into the device’s various inputs as required.
This may include line-signal devices, as well as
microphones and/or guitars, keyboards, etc.
4. Plug any necessary equipment into the device’s
various outputs. This could include monitors,
signal processors, and/or recording devices.
5. Ensure all input and out levels are set to the left-
most position.
6. Plug the supplied AC cable into the AC inlet on
the back of the RoadGear mixer.
NB. Ensure the power cable has no scratches or cuts that may
reveal the wire beneath before plugging into the provided
powered mixer as constant setting up and disassembling of
equipment may cause insulation to wear.
7. Plug the supplied AC cable into a power outlet of
a suitable voltage.
8. Turn the mixer power switch to the on position
and set all input and output at appropriate levels
to suit your needs.
9. When the RoadGear is in use, the storage
compartment door must be kept open for better
ventilation.
1
���� �����������
��������� �� ����