Phonic POWERPOD 1060, Руководство пользователя

Страница: 6 / 27

page 5
PHONIC CORPORATION POWERPOD User's Manual
4. Plug any necessary equipment into the device's
various outputs. This could include speakers, monitors,
signal processors, and/or recording devices.
NB.
No devices other than speakers should be connected to the power
amp outputs. Plugging inappropriate devices into the mixer will
likely cause damage to the device. Also, guitar cables should not be
used to connect amplifi ers to speakers.
5. Plug the supplied AC cable into the AC inlet on the
back of the device, ensuring local voltage level is
identical to that selected by the Voltage Selector on
the rear of your device.
6. Plug the supplied AC cable into a power outlet of a
suitable voltage.
7. Turn the power switch on.
Channel Setup
1. To ensure the correct audio levels of each input
channel is selected, every channel faders should
fi rst be set to 0.
2. Choose the channel that you wish to set the level of,
and ensure that channel has a signal sent to it similar
to the signal that will be sent when in common use.
For example, if the channel is using a microphone,
then you should speak or sing at the same level the
performer normally would during a performance. If
a guitar is plugged into that channel, then the guitar
should also be used as it normally would be.
NB.
It is probably best to have nothing plugged into channels which are
not being set, just to ensure no signal is inadvertently sent through
the channel.
3. This channel is now ready to be used; you can stop
making the audio signal.
4. You should now select the next channel to set and
go back to follow steps 1 through 3.
matching
Handy mini-stereo I/O for MD, MP3 player/recorder,
input with level control
Mains power switchable between 115VAC and
230VAC
Powerpod 1062
375W + 375W / 4 ohms amplifi er for main L & R or
main / monitor (Bridge mono, 750W / 8 ohms)
24-bit digital stereo multi-effect processor with 16
programs plus one main parameter control, tap
control and foot switch
Dual 10-band graphic equalizers with In/Out switches
for main(stereo)/monitor or main L/R
9 balanced mic inputs through XLR jacks
12 line inputs through 1/4" jacks
2 Super Hi-Z inputs optimized for direct input of
acoustic electric guitars and electric guitars or
basses
2 built-in limiters
Rumbling fi lters for mic inputs
3-band channel EQ
Pad control on channel 1~6
Monitor and effect sends on each input channel
Stereo aux input
+48V phantom power
Record output with trim control for recording level
matching
Handy mini-stereo I/O for MD, MP3 player/recorder,
input with level control
Mains power switchable between 115VAC and
230VAC
BASIC SETUP
Getting Started
1. Turn all power off on the Powerpod Mixer. To ensure
this, the AC cable should not be connected to the
unit.
2. All faders and level controls should be set at the
lowest level to ensure no sound is inadvertently sent
through the outputs when the device is switched on.
All levels should be altered to acceptable degrees
after the device is turned on.
3. Plug all necessary instruments and equipment into
the device's various inputs as required. This may
include line signal devices, as well as microphones
and/or guitars, keyboards, etc.