Phonic MM 1805, Руководство пользователя

Страница: 12 / 40

11
26
. BALANCE
The BALANCE control sets the amount of the channel signal feeding the ST
mix output, allowing you to balance the source in the stereo image. When
the control knob turn fully to the left or right, you send only that side of the
signal to the mix.
27
. Peak LED Indicator
Same as the mono channel PEAK (13).
LED lights up when an excessively high signal level is present in the
channel. In general, Input level should be set to the level where the LED
flashes briefly on the loudest peaks only, if it flashes continuously, turn the
input control down slightly. This ensures the best possible signal-to-noise
ratio and dynamic range.
28
. CHANNEL ON/OFF SWITCH
Same as the mono channel on/off switch (14).
All outputs from the channel except inserts are enabled when the switch is
down, when the On switch is released, the related channel is muted. This
allows levels to be preset before the signal is required. The indicated LED
will light up when the channel on button is pressed.
29
. GP
Same as the mono channel GP switch (16)
30
. PFL
Same as the mono channel PFL switch (17).
Pre-Fader-Listening, when PFL switch is pressed, the pre-fader signal will
be fed to control room/headphones output, where it replaces the selected
monitor source. PFL is very useful for mixing engineer to monitor individual
channel without affect the main mixes when they are making adjustments
or tracing problem. When PFL button is pressed, the indicated LED will
light on.