9
14
15
16
17
19
18
20
➅
OPTIONS:
Here it is possible to attach a module including 3 microphone-/
line-inputs, a module for two TOA WTU 860 diversity receivers
(37 MHz) or two TOA WTU 4800 diversity receivers (800 MHz).
See installation of options in section 3.2 Options.
➆
TAPE IN:
The two phono connectors make it possible to connect an
external
unbalanced
line
signal.
➇
TAPE OUT:
TAPE OUT is two separate phono connectors L and R with an
unbalanced line signal similar to the signal from the teleloop
output.
➈
CH 1 & 2:
CH 1 & 2 are two electronically balanced XLR line or micro-
phone connections, that make it possible to connect external
balanced signals. The XLR connector is connected by pin 2
high(+), pin 3 low(-), and pin 1 ground (GND).
➉
PAD:
Press the PAD switch in to reduce sensitivity by 30 dB, so that
the signal is a standard line input. Press the PAD switch out and
CH 1 & 2 are standard microphone inputs.
TRIM:
TRIM control compensates for the input signal strength on CH
1 & 2. The trim potentiometer is adjusted, so that the +10 dB
does not light constantly. The light should only blink during loud
passages otherwise the signal is too high.
PHA PWR:
When this switch is active, it gives a +15 volt Phantom Power to
input CH 1 & 2.
NB!
Only use Phantom Power for microphones
that requires it, otherwise there is a risk that the equipment
can
be
damaged.
These features are not active in the LogiBit 1200. They are only
active
in
the
LogiBit
1260.
SQ2B:
The red diode shows, when receiver 2 uses antenna B.
SQ2A:
The green diode shows, when receiver 2 uses antenna A.
SQ Adj 2:
This is a trim control, used to adjust the squelch on receiver 2.
See also section 3.2 Options under Squelch.
Ant B:
The antenna port is used by both receiver 1 and 2. See also
section 3.2 Options under Installation of external antenna.
Ant A:
The antenna port is used by both receiver 1 and 2. See also
section 3.2 Options under Installation of external antenna.
SQ Adj 1:
This is a trim control, used to adjust the squelch on receiver 1.
See also section 3.2 Options under Squelch.
SQ1A:
The green diode shows, when receiver 1 uses antenna A.
LogiBit 1200 manual
Features on the Back Panel
11
12
13
Содержание LOGIBIT 1200
