Phonetics Sensaphone 4100, Руководство пользователя

Страница: 13 / 68

TURNING THE MODEL 4100 ON
The ON and OFF keys on the Model 4100 keypad are used to activate and deactivate the
unit. To turn the unit ON, press the ON key. The system ON light will begin to glow. The
unit will say “Hello,” or beep if it is already on.
When the unit is ON, it is able to receive incoming calls and automatically dial out in the
event of an alarm on one of the monitored conditions. The red light will glow as long as the
unit is on.
When you press OFF, the 4100 will say “Have a good day,” and the system ON light will
stop glowing. All functions are disabled except the battery backup. The batteries will still
discharge if the AC transformer is unplugged from the 110 VAC outlet.
It is not recommended that the unit be turned OFF unless absolutely necessary. (See
“Disconnecting the Model 4100” later in this chapter.) Full power is still consumed by the
unit even though it cannot be programmed or interrogated. Also, the unit cannot dial out
with an alarm.
STRAIN RELIEF
A strain relief clamp is provided in the Model 4100 enclosure to prevent wiring from being
pulled from the circuit board or damaged when passing through the enclosure. To use the
strain relief, thread wires through the clamp and clear rubber bushing. Position the bushing
in the clamp and tighten the screws on either side so that the wiring does not move.
See Figure 2:
Figure 2: Strain relief clamp
PHONE LINE INSTALLATION
The Sensaphone Model 4100 will operate with all standard analog telephone systems that
accept pulse or tone dialing. The Sensaphone Model 4100 cannot be used on an extension
line to dial its own telephone number. Also, it may not be installed on a party line or pay
telephone line.
Certain private telephone systems and public switching equipment may not accept
Sensaphone dialing or may generate an unacceptable ring signal. In those cases, a dedicated
line may be required for the 4100. Consult the supplier of your telephone system if you
encounter problems.
11
Chapter 2: Installation