Phoenix Spider MT503 SMART, Руководство пользователя

Страница: 5 / 12

CONNECTING TO A COMPUTER
This connection is for any session using your computer, such as Voice over IP applications
(Skype, Vidyo, etc.).
‣ Using the USB cable provided, plug the micro USB side of the cable into the Spider
(USB connector located on the connector panel below the unit).
‣ Plug the USB end of the cable into any USB port on your computer.
No additional drivers or steps are needed. However, we do recommend downloading and using
our “Phoenix Audio Setup Utility” for optimal audio control and performance. This utility can be
found on our website:
www.phnxaudio.com/downloads/audiosetup/
CONNECTING TO A SMART DEVICE
This connection is for any session using a smart phone, tablet, or any device that requires an
analog audio signal (Smart Phones, Tablets, Video Codec Systems, etc.).
‣ Using the provided audio cable or any custom made cable, plug the 2.5mm 3-pin
connector side into the Spider’s “Audio Out” jack (located on the connector panel below
the unit).
‣ Plug the other end of the provided cable (3.5mm 4pin connector) into your smart phone
or tablet’s headphone / headset jack.
‣ Connect your Spider to a power source using either a USB connection (computer or the
provided 5V USB power supply) or a 48V Daisy Chain Kit power supply. Your Spider is
now ready for use.
USING THE SPIDER
THE DIRECTIONAL ARRAY
During a call the Spider uses a proprietary Beamforming technology to locate a legitimate voice
source, and to steer an array towards it. This allows the Spider to focus on the speaker in the
room and to cancel out all other noises.
The Beamforming process is dynamic and adjusts the direction of the array when the source of
sound changes or moves. When in a call and a voice is detected in the room, a single or
multiple blue lights located under the grill will indicate which direction the Spider’s audio beam is
Page 5