MP-MX-3
- 4 -
™
ReaR
1 GND
2 +IN
3 -IN
1
2
3
2
3
1
0 dB/+6 dB
Jumper to select the
output signal
0 dB or +6 dB
POWeR SUPPlY
cOnnecTIOn
Voltage supply 24VDC,
please note the
correct po/-
lIne OUT
Output, used for
connection to power
amplifier or mixing
preamplifier or to the
main control unit
lOW/hIGh On-OFF
Jumper switch can
be used to enable or
disable the functions
of the LOW-HIGH
controls on the front
panel
lOW cUT
Jumper for activating
or deactivating the
LOW CUT filter;
Please reposition
two jumpers per
input
PhanTOM POWeR
Switch for switching on the PHANTOM
POWER for condenser microphones. Please
note that PHANTOM POWER may only be
activated for condenser or balanced dynamic
microphones; PHANTOM POWER should
not be active with unbalanced microphone
cables.
© copyright 2018, Phoenix Professional audio Gmbh, www.phoenix-pa.com
Phoenix logo is registered with the DE Patent and Trademark Office (TM)
All trademarks are the property of their respective owners
Instruction manual
Balanced inputs: Strip the wire conductors by 6 mm
and connect them to the terminals as shown. Tighten
the screws.
Unbalanced inputs: Strip the wire conductors by 6 mm and
connect them to the terminals as shown. The center pin
must be connected to the shielding pin as shown. Tighten
the screws.
1 GND und wire bridge to 3
2 +IN