Phoenix BigSound PB17, Руководство пользователя

Страница: 6 / 27

Initial Checkout
The Basic Bench Test
Each system is tested before shipping but we recommend that you hook
things up on your workbench, play with the system and get comfortable with the
components before installation.
The power supply connects to Terminals 1 & 2. A power source of any
polarity is acceptable. The maximum peak input voltage is 30 volts. If you are
using a volume switch plug it into Terminals 3,4 & 5. The speaker connects to
Terminals 7 & 8.
Until the battery is charged, you will not get sound until the external power
supply reaches near 6 Volts. Also, since the board runs off the battery below 6
Volts, you will not get idle sounds and you will not be able to adjust the starting
voltage until the battery is charged.
Maximum battery charging occurs above 6 Volts (30 minutes will bring the
battery up enough for normal operation). With a charged battery, the sound
system should play the idle sounds for approximately 30 seconds after turning
off the power supply and then shut down.
Diesels will rev up and down as you adjust the supply voltage. A steam
engine system on the other hand will sit in idle (Coal Shoveling and Air
Compressor play periodically) until it sees motion contacts connecting terminal
11 to ground. Each closure produces a Chuff. At first Chuff, the directional toots
play and the bell starts ringing.
Steam can be configured to run off of voltage and diesel can be changed to
look for wheel rotation. We initially set them up the way most modelers will use
them.
January 2018
- 6 -