Phoenix 2700 DHP
July 2018
22
6.
Push the two film webs between the front rollers using a treading card or piece
of thin cardboard.
7.
Return the gap adjustment handle down to the “Laminate” position.
8.
Use the motor switch on the control panel to advance the film web through the
front rollers and between the rear pull rollers, until the threading card can be cut
from the web at the rear of the machine.
9.
Return the feed tray into position.
10.
Return the safety shield into position.
Note: The film should be smooth and taught to the surface of the heat roller.
If the film is not tight enough, adjust the brake tension on both sides of
both top and bottom film rolls.
23. Adjusting Brake Tension
1.
To remove wrinkles in the film web, tighten the brake adjustment on each film
supply shaft using the supplied Allen wrench.
a.
Clockwise to increase brake tension.
b.
Counterclockwise to loosen brake tension.
Note: Do not over tighten the brake tension. Apply only enough tension to
the film web to smoothen out wrinkleless before they enter the laminating
nip point and appear on the printed material.
Allen wrench
Adjustment screw
hole
