YAK54 MK2
Instruction Manual
3
Cut off shaded portion
Assemble left and right
sides the same way
Nut
3mm
6
< Bottom view >
3 x 25mm Cap Screw
2
85mm Push rod
2
2
2
2
3 x 12mm Screw
Aileron
Aileron
INSTALLING THE AILERON LINKAGES
1. Install the control horn into the aileron.
2. Locate the metal rod wire, screw the plastic link ball
onto the threaded end of the wire. Tighten the nut
against, and then install the metal M3 clevis to the
other side of the pushrod wire.
3. Plug the aileron servo into the receiver and center
the servo. Install the servo arm onto the servo. The
servo arm should be perpendicular to the servo and
point toward the middle of the wing.
4. Center the aileron and hold it in place using a
couple of pieces of masking tape. Adjust the
linkage until the aileron and the servo arm are
both centered and then tighten the nut against.
Remember use thread locking compound to
secure.
5. Repeat step 1 - step 4 for the second aileron
linkage.
