Installation
CONTROL UNIT HE200
14
82687(-)
CAUTION
You should only connect and disconnect the cables when they are completely disconnected from
any live current!
Screw the control unit onto the end product (as shown in Figure 6 ). Use the mounting holes shown
in Figure 5 located on the control unit. Use screws meeting the requirements of DIN 7049 with 4.8
mm diameter and of suitable length (5 mm plus the screw-in depth into the end product).
Proceed with the installation as follows:
1
Mark the drill holes.
2
Drill the two holes for the screws in the end product.
3
Screw in the two screws so the CONTROL UNIT HE200 is securely mounted to the end product.
Figure 6
Installing the CONTROL UNIT HE200
1
3
2
