Information about creating your Operating Manual
CU458-2
18
93728 1.0
3
If, during the RF1058 remote's pairing process, you press any button on an already paired
RF1058 hand-held remote, then it switches to the
Bluetooth
®
pairing mode.
If the RF1058 remote or a
Bluetooth
®
device is discovered during the pairing phase, then this
pairing mode is automatically ended. The floor lighting and the pairing LED switch off.
4
If automatic configuration must be repeated: Remove the plug from the power supply and wait
60 seconds. Then insert the plug back into the power supply. You can then start the new pairing
process.
NOTICE
Only start
one
system at a time. Never configure multiple systems simultaneously.
7.2.2
Manual configuration
The floor lighting will flash twice to acknowledge successful completion of the process.
1
Insert the power plug into a power outlet.
2
Press the Reset button on the CONTROL UNIT twice in quick succession (see Figure 2, page
10). The floor lighting and the pairing LED light up.
The CONTROL UNIT remains in pairing mode for 120 seconds. The pairing mode is split as fol-
lows:
•
A RF1058 hand-held remote can be paired in the first 60 seconds.
•
A
Bluetooth
®
device can be paired in the second 60 seconds.
During the RF1058 pairing phase, the floor (under-bed) LED and the paring LED on the CON-
TROL UNIT light up.
3
Press the
+
buttons on the RF1058 hand-held remote simultaneously (see RF1058
hand-held remote instructions). A successful pairing will be acknowledged.
The floor lighting will switch off after the pairing process for the hand-held remote RF1058 is fin-
ished. The pairing LED for pairing a
Bluetooth
®
device starts flashing.
The pairing LED switches off when the
Bluetooth
®
pairing process has timed out or when the
device has connected successfully. A successful pairing will be acknowledged.
NOTICE
Only start
one
system at a time. Never configure multiple systems simultaneously.
