Check all the cables and tubing are connected
to the scanner and that they are suitably
grouped and tethered to prevent accidental
damage.
2
Adjust the probe height by winding the central
screw of the water box in as far as possible
using the large thumb screw. Ensure the water
box is fully retracted in the buggy.
Adjust the separation of both sets of wheels
to the correct pipe size to be tested using the
graticules marked on the scanner.
Fine tune the wheel separation if necessary so
that all four wheels are centred to run on a
radial line.
2.2
2.1
Attach the magnetic wheels on the buggy to
the pipe.
Wind the water box towards the pipe until all
of the seal is in contact and concentric to the
pipe.
2.4
2.6
2.3
2.5
2. Mounting Sp-Arc
Sp-Arc
3
