Phoenix Contact RFC 4072S, Руководство пользователя, Страница: 84 / 272

RFC 4072S
84 / 272
PHOENIX CONTACT 108580_en_02
Connect the power supply to the device. – Notes on using PELV power supplies in Section “Elec-
trical safety” on page 15
– Section “Connecting the supply voltage” on page 76
Switch on the power supply to the device.
Carry out all the steps in order to integrate the device as a
PROFINET controller in a PLCnext Engineer project.
– Online help for PLCnext Engineer
– Section “Integration of the RFC 4072S in
PLCnext Engineer as a PROFINET controller” on
page 89
Assign the necessary IP address settings for your applica-
tion to the device.
Section “Configuring the controller IP settings” on page 93
Check the PROFINET controller settings and adapt the set-
tings, if necessary.
You can operate the RFC 4072S concurrently as a
PROFINET controller and PROFINET device.
Send your settings to the controller.
Section “Important information” on page 93
Create the bus configuration in PLCnext Engineer. Section “Adding PROFINET devices” on page 100
Assign a PROFINET device name for the connected devices
(device naming).
Section “Assigning online devices (device naming)” on
page 101
In PLCnext Engineer, set the F_Source_Address
(F_Source_Add) and the F_Destination_Addresses
(F_Dest_Add) that are set on the safe F-Devices.
Table 4-1 Steps for initial startup of the RFC 4072S
Step Relevant section and literature
Make sure that the PROFINET devices and F-Devices used in your application have been mounted and
installed correctly before switching on the supply voltage.
WARNING:
Take appropriate measures to ensure that your
system/machine does not present any danger
during startup and validation.
WARNING:
The planned system/machine safety function is
only available following validation.
Please note that the RFC 4072S requires approximately two minutes to start up. This is due to the comprehen-
sive selftests the device must perform. The status is indicated on the display.
The following steps must be performed in the PLCnext Engineer software.
When carrying out the following steps, please refer to the online help of the software. The online help assists
you in programming and parameterizing the PLCnext Engineer software.