Phoenix Contact RFC 4072S, Руководство пользователя

Страница: 73 / 272

Mounting, removal, electrical installation, and replacement
108580_en_02 PHOENIX CONTACT
73 / 272
Figure 3-3 Mounted RFC 4072S with end brackets and maximum distance between
the DIN rail fastening points (160 mm)
3.4 Removing the RFC 4072S
To remove the device, follow the instructions in Section “Replacing the RFC 4072S” on
page 77 up to step 5.
3.5 Inserting/removing the SD card (parameterization
memory)
Inserting (A) and removing (B) the SD card is graphically shown in Figure 3-4 .
Inserting the SD card • Insert the SD card in the slot provided with the contact strip to the front (A).
When pressed lightly, the SD card snaps into place.
NOTE: Please note that the SD card may not be inserted or removed during operation. If
the SD card is removed/inserted during operation, the RFC 4072S will switch to the safe
state (failure state).
Always disconnect the power supply to the RFC 4072S before inserting or removing the
SD card.
The SD card is recognized during initialization of the RFC 4072S. Make sure that the SD
card has been inserted before switching on the RFC 4072S to enable the device to use it.
NOTE: SD card (parameterization memory) – formatting note
The SD card is already formatted and is intended for use with Phoenix Contact devices.
Make sure that the SD card is not reformatted outside the RFC 4072S.
NOTE: Potential damage to the device
When inserting the SD card, make sure that it is located in the guide rails on both sides of
the card holder.
To prevent damage to the device, make sure that the SD card is properly aligned and
never forced into the slot.
160
RUN/PROG
STP
MRESET
DISPLAY
Or
d.No
.2404577 RF
C 480S PN 4TX
1 2
LAN
3.2
LAN
3.1
LAN
LAN
107586A020
g