QUINT4-PS/12-24DC/5-15DC/2.5/PT
110260_en_00
PHOENIX CONTACT
18/30
8
Mounting/removing the power
supply
8.1
Mounting the power supply unit
Proceed as follows to mount the power supply:
1. The power supply is mounted in the normal mounting
position from above onto the 35 mm DIN rail (DIN EN
60715). Make sure that the integrated snap-on foot is in
the correction position behind the DIN rail (A).
2. Then press the power supply down until the integrated
snap-on foot audibly latches into place (B).
3. Check that the power supply is securely attached to the
DIN rail.
Figure 7
Snapping the power supply onto the DIN rail
8.2
Removing the power supply unit
Proceed as follows to remove the power supply:
1. Take a suitable screwdriver and insert this into the lock
hole on the integrated snap-on foot (A).
2. Release the lock by lifting the screwdriver (B).
3. Carefully swivel the power supply forward (C) so that
the lock slides back into the starting position.
4. Then separate the power supply from the DIN rail (D).
Figure 8
Removing the power supply from the DIN rail
B
A
Click
B
A
D
C
