FL BT EPA
20
PHOENIX CONTACT
7900_en_01
2.1.1
Configuration using the MODE button
Figure 2-1
MODE button on the bottom of the FL WLAN EPA - Above the MODE button
are LEDs “A” to “D” for configuration indication
General sequence:
•
Connect the module to the power supply.
•
Within 5 seconds
of switching on the supply voltage, briefly press the MODE button
to access configuration mode.
•
Select the desired operating mode by repeatedly pressing the MODE button until the
corresponding LED combination lights up. Once you have scrolled through all the LED
combinations (operating modes), the selection automatically starts again from the
beginning.
•
After selecting the desired operating mode, exit the configuration by pressing the
MODE button (> 2 seconds) until the LEDs flash or go out (upon reset or when exiting
configuration mode).
If the module has been previously configured, we recommend restoring the device's default
settings before configuring the device via the MODE button. This action is also performed
via the MODE button.
If the MODE button is not pressed in the active configuration mode for an extended period,
the configuration mode is automatically exited and the EPA is started in its previous setting.
Table 2-1
Permissible LED combinations when starting up via MODE button
Mode
Operating
mode
Configuration setting
LEDs
A
B
C
D
1
PANU
Activate DHCP server
The EPA operates as DHCP server and, for example, assigns
address 10.0.0.1 to a computer which is connected for configuration
purposes via DHCP. Not to be used for operation in a network.
A
2
PANU
Reset the device to the
default settings.
B
3
PANU
Reset the
IP parameters
to the default settings (10.0.0.100). Other
settings are not modified.
A+B