Philips VidQuad LTC 2372, Руководство по установке

Страница: 9 / 20

9
4.2 LTC 2376 & LTC 2377 Connection
Video Inputs:
Camera 1 Video Input 1 - BNC
Camera 2 Video Input 2 - BNC
Camera 3 Video Input 3 - BNC
Camera 4 Video Input 4 - BNC
Video Outputs:
Monitor Video MON - BNC
2
Loop-through 1 Video Output 1 - BNC
3
Loop-through 2 Video Output 2 - BNC
3
Loop-through 3 Video Output 3 - BNC
3
Loop-through 4 Video Output 4 - BNC
3
VCR Out VCR IN - BNC
VCR In VCR OUT - BNC
4
Alarm/Remote:
Pin Function
1 Alarm IN (1)
2 Alarm IN (2)
3 Alarm IN (3)
4 Alarm IN (4)
5 Alarm IN (Common)
6 Alarm Trigger OUT (Signal)
7 Alarm Trigger OUT (Ground)
8 Alarm Trigger OUT (Ground)
9 RS-232 (Rx)
10 RS-232 (Ground)
11 RS-232 (Ground)
12 No Connection
13 Alarm Relay OUT (NC)
14 Alarm Relay OUT (Common)
15 Alarm Relay OUT (NO)
RS-232 protocol
6
Data Rate 1200 Baud
Data Bits 8
Parity None
Stop Bits
1
Video Inputs/Outputs:
Camera 1 Video Input 1 - BNC
Camera 2 Video Input 2 - BNC
Camera 3 Video Input 3 - BNC
Camera 4 Video Input 4 - BNC
Monitor Video Mon - BNC
ALARM / REMOTE
1
2
4
3
1 2
3 4
CLASS II
MON
VCR
IN
MADE IN KOREA
OUT
GND
Alarm inputs are Class 2 input only.
Alarm input cables must be shielded, and the shield must
be grounded.
NOTES:
1. The LTC 2377 provides a COLOR Adjustment menu to assist initial
monitor adjustment.
2. If the video line ends at the system monitor, set the monitor’s
termination switch to 75 Ohm. If the video is looped through the
monitor to some other item of equipment, set the monitor termination
switch to HIGH Z or HIGH IMPEDANCE. The last video in the line
must be terminated with 75 ohm.
3. If the video is to be looped out to other equipment, make sure that the
final item of video equipment on each line is terminated with 75 ohm.
4. The VCR or DVR can be connected to the unit to allow it to respond to
alarms.
5. Do not apply any voltage to any alarm input. It will damage the unit.
6. Set the host computer to the half-duplex mode. The LTC 2376 and
LTC 2377 do not echo received characters.
7. If less than 4 inputs will be connected to the LTC 2376 or LTC 2377, an
on-screen Vid Loss message will be displayed on unused channels. To
disable message display, enter the Sequence Setup menu and set the
unused channels to the SKIP setting.
Figure 3 LTC 2372 & LTC 2375 Connection
4 INSTALLATION
4.1 LTC 2372 and LTC 2375 Connection
MADE IN KOREA
1 2
4 3
VIDEO IN
1 2
3 4
CLASS II
MON GND
Figure 4 LTC 2376 & LTC 2377 Connection