GETTING STARTED
This remote is ready to work with any Philips TV.
For other brands of equipment, it needs to be set up first. That only
takes a couple of seconds, thanks to Philips' Simple System Setup!
Before you start
make sure the equipment is switched on.
Sit right in front of it.
If you know the brand of your equipment,
look at the code list at the
back of this booklet, and find the first 5-digit code for your equipment.
1
Press and hold
s
and
y
at the same time until the green LED lights
up. (Release the keys, the green LED should stay on)
2
Enter the 5-digit code using the numbers that correspond to the
function keys (see diagram). The green LED blinks twice.
That's it!
Now, press a few keys on the remote to check that the
equipment responds correctly. If it doesn't, try again using the next code
in the list. In the rare instance that none of the codes work, follow the
instructions in the next section.
Tip:
Make a note of the code inside the battery case, and in the back of
this booklet in case you ever need to setup again.
If you don't know the brand of your equipment
or if you can not find
it in the codelist, setup still won't take long. Philips' patented Handsfree
autosearch tests all the codes one after another and finds the right one
for you! The search time averages about 90 seconds.
(Maximum search time is 5 minutes for TV.)
Make sure
the TV is switched on. You will know when the correct code
has been found because the equipment will switch off.
1
Press and hold
s
and
y
at the same time until the green LED lights
up.
2
Press
y
to start the search.
Each time the green LED blinks, another code is sent.
When the right code is found, the equipment switches off.
3
Immediately press
y
to stop the search.
If you missed
the correct code because the search went too far, switch
the equipment back on, then press
to send the previous code again.
Press
repeatedly until the equipment switches off again.
4
Once you've found the correct code, press
y
to lock it in memory.
The green LED blinks twice.
That's it!
Now, switch the equipment manually on again, then press a
few keys on the remote to check that the equipment responds correctly.
In the rare instance that it doesn't, try again from step 1 to find a
better code.
PROG
PROG
Instructions for use
English
5
English
XP SBC RU 151.1 booklet 31-01-2003 11:08 Pagina 5
