34
3
On the PC, launch the WADM on the PC
to update the firmware.
I have problems installing WADM or launching
WADM after installation, what do I do?
Ensure that the operating system of the
•
PC meets the requirements.
Ensure that the PC is virus-free.
•
Some files on the USB device are not
displayed, what do I do?
Check if the number of folders exceeds
•
99 or the number of titles exceeds 999.
Only completely recorded MP3/WMA
•
files can be found and played. Check if the
file has been recorded completely.
DRM-protected WMA files cannot be
•
played.
The remote control does not function
properly, what do I do?
Reduce the distance between the remote
•
control and Wireless Micro Hi-Fi System.
Insert the batteries with correct polarity
•
(+/- as indicated inside the battery
compartment).
Replace the batteries.
•
Point the remote control directly at the
•
infrared sensor.
The screen of Wireless Micro Hi-Fi System is
stuck in a menu or shows no response for a
long period of time (2-5 minutes), what do I do?
Press
•
/ON/STANDBY/ECO-
STANDBY
.
If the problem persists, restart the power
•
(disconnect and reconnect the power
plug) to reset Wireless Micro Hi-Fi System.
‘No Disc’ / ‘Cannot read CD’ is displayed,
what do I do?
Insert a suitable disc.
•
Check if the disc is inserted with the
•
graphics side (label) facing up.
Wait for the condensation moisture on
•
the lens to clear.
Replace or clean the disc.
•
Use a finalized CD-RW or CD-R.
•
it is different from the SSID that your
neighbors use for their router.
Wireless Micro Hi-Fi System supports
•
wireless and wired connection at the
same time. There is a chance that your
wireless IP address and your wired IP
address are on the same subnet. This will
confuse the device. Consider changing the
DHCP range of your wireless router so
that the wireless IP received by the device
is on a different subnet from its wired IP
address.
Try to change the channel of your home
•
network settings on the router.
On your router, consider using a WPA
•
key instead of a WEP key. When you use
a WEP as your encryption key, set all 4
keys to be the same.
Ensure that the turbo mode of your
•
wireless router is switched off, if your
router has this function.
After ripping music from a CD the data is lost,
why is that?
The CD rip process consists of various stages
(ripping, compressing, converting, etc.). After
the initial CD rip stage is complete, It takes
approximately 15 minutes to process the
ripped data. This happens in the background
and during this time you can operate Wireless
Micro Hi-Fi System as normal.
Solution to avoid loss of data during or after
CD rip:
do not switch to eco standby during rip
•
process
do not disconnect Wireless Micro Hi-Fi
•
System from the power supply for at least
15 minutes after the rip process stops
The wireless firmware update failed, what do
I do?
1
Ensure that the PC is connected to the
Internet.
2
Use an Ethernet cable (sold separately) to
connect Wireless Micro Hi-Fi System to
the PC.
EN