SpaceWise for Office Applications
v. 3.7
12
Philips Lighting North America
To select light output settings, use the up and down arrows to
change between high, medium, low and minimum. Light level
can be altered one step at a time. The daylight button must be
pressed to initiate a new change after every end of step.
b.
FOR EACH STEP UP OR DOWN:
Point to
any
of the luminaires in the
group and press “daylight.”
While the LED is still blinking red, select:
OR
Then press “send.”
END OF STEP
Red LED on remote will start
blinking.
Red LED on remote will stop
blinking.
This will move the light output
setting by one step. The
luminaire may or may not flash at
the end of the step depending
upon firmware version.
Note that the default setting is Medium. To get to high, go one step up. To get to
Minimum, go two steps down.
Medium to High:
Will move light output setting from default of 88% to 100%.
Medium to low:
Will move light output setting from default of 88% to 77%.
Low to minimum:
Will move light output setting from 77% to 66%.
During programming, the fixture is temporarily at 50% (unlocked state). So, while
changing the light level from default 88% to 77%, you will notice the fixture getting
brighter because it is actually going from the temporary 50% light level to
permanent 77% light level. If you repeat the step down sequence again then upon
careful observation you will see the subtle change in light level from 77% to 66%.
Содержание SpaceWice
Страница 1: ......
Страница 42: ...SpaceWise for Office Applications v 3 7 41 Philips Lighting North America ...
