Headphone
1
On/off switch: check if the power button of the headphone is in the on
position.
2
System status LED:
the system status LED on the control panel will indicate
the status of the headphone by means of different colours and different
blinking modes Some of these modes also have an audible alarm.The table
will show all possibilities of system status and alarm sounds.
Definition
Indication
Required action
Power on but
LED:
RED on
Press tuning button on headphone
no radio signal
or change transmission channel on
base station or switch on transmission
function on base station
Power on and
LED:
GREEN on
tuned
Tuning/searching
LED:
GREEN blinking
Battery running
LED:
RED blinking
You have a limited time to replace the
low
Sound:
1 serie of
batteries before the headphone will
(5x100 ms) beeps
go in power save mode.
Battery empty
Sound:
3 series of
Replace the battery pack.
(5x50 ms) beeps(headphone will go
in power save mode once the
batteries are empty)
Power save mode
LED:
RED blinking (2 seconds)
Please read point 5 of this chapter on
and short GREEN burst (all other
the next page.
indicators on the headphone are
turned off)
Out of range
Sound:
1 serie of
Move closer to the base station.
(5x200 ms) beeps
ENGLISH
32
XP SBC HD 1500/17 for USA 14-01-2004 13:34 Pagina 32
